Sliding Glass & Patio Doors in Boynton Beach - Free In-Home Measure, Written Price

Trusted Sliding Glass & Patio Doors for Boynton Beach Homeowners

A sliding glass patio door that binds in July, lets in rainwater during a summer squall, or has a fogged seal between the panes is telling you something: the track is out of true, the rollers are shot, or the seal has failed. In Boynton Beach, where salt air and humidity work on metal tracks year-round, these problems show up faster than a homeowner expects. TruePane Windows & Doors has installed and repaired sliding glass and patio doors in Boynton Beach since 2008 through our founder Dale Kessler’s family craft tradition. We answer the phone with a live person 24/7 at (561) 708-6771, and we quote the job on paper before any work begins.

Call (561) 708-6771

What Our Sliding Glass & Patio Doors Service Includes

Sliding Glass Door Replacement

Replacing a sliding glass door in Boynton Beach usually means pulling out a builder-grade aluminum frame that has corroded at the threshold and swapping in a new unit sized to the exact rough opening. We replace sliding doors with impact-rated options from PGT and CGI, which matter in a coastal market where windborne debris codes apply east of Federal Highway and into the barrier islands. Our technicians measure every opening twice, register both manufacturer warranty layers in writing before leaving your driveway, and haul away the old door and track.

Patio Door Installation

A new patio door installation is only as good as the plumb and level of the rough opening. If the framing is out even an eighth of an inch, the door will bind at the latch and leak at the sill within a season or two. We shim, square, and seal the opening before the door goes in, then set the rollers and lock strike so the door glides with two fingers. Dale Kessler’s rule governs every install: if the pane is not true, the job is not done.

Sliding Door Track Repair and Realignment

When a slider drags or jumps off the rail, the cause in Boynton Beach is usually a combination of salt corrosion, worn roller bearings, and a track that has settled out of level. We clean or replace the track, install new rollers matched to the door weight, and realign the panel so it latches without lifting. This is the kind of repair that restores a door to its original swing in a single visit, and it is covered under our Done Right Promise.

Sliding Glass Door Roller Replacement

Rollers are the disposable part of any sliding door system, and in coastal Florida they corrode faster than manufacturers predict. We stock OEM and aftermarket rollers for most major lines, including PGT, CGI, Andersen, and Pella, and we replace them in matched pairs so the door rides evenly. A door with one new roller and one old roller will still bind; we don’t cut that corner.

Sliding Door Weatherstripping and Seal Replacement

Worn weatherstripping on a sliding patio door lets in humidity, rainwater, and insects, and it forces your air conditioner to work against a leak you can feel with your hand. We replace the wool pile, vinyl fin, and threshold gasket with materials rated for marine exposure, because Boynton Beach is a marine environment in practical terms. This simple job lowers indoor humidity and keeps the door from chattering in wind gusts.

Sliding Glass Door Hardware Replacement

Latches, handles, locks, and foot bolts on sliding doors fail from years of use and salt exposure. We replace hardware with manufacturer-matched parts when available, or with upgraded stainless components when the original zinc hardware has pitted. A sliding door that does not lock properly is a security issue, and a handle that falls off is a sign the internal mortise mechanism has stripped; both are repairable without replacing the whole door.

Glass Replacement for Sliding and Patio Doors

Impact-rated glass in a slider can crack from a lawnmower stone or a hurricane branch without the whole frame failing. We replace individual lites in sliding door panels, matching the tint and Low-E coating so one pane does not look like a patch. When the seal between the panes fails and the glass fogs, replacement is the only lasting fix, and we specify the new insulated unit to match the original glass package.

Brands We Service for Sliding Glass & Patio Doors

TruePane is an authorized installer for PGT and CGI sliding glass and patio doors, and we have installed hundreds of PGT WinGuard and CGI Estate Collection sliders in Boynton Beach communities from Chapel Hill to the Intracoastal. We know how PGT’s impact glass package sits in its frame, how to register the PGT warranty so it transfers to a second owner, and how to set CGI’s stainless roller carriages so the door floats instead of dragging. When a PGT or CGI door needs a replacement part after a storm, we can usually source it directly through our supplier relationship faster than a homeowner working through a big-box store.

We service Andersen and Pella sliding doors as well, including older models where the manufacturer no longer stocks the original roller. In those cases we machine-match a replacement roller from our stock and adjust the track profile to match. Therma-Tru patio doors also cross our workbench regularly, especially in newer Boynton Beach developments. Whether you have PGT, CGI, Andersen, Pella, or any other make, we quote the repair or replacement on paper before any work begins.

Signs You Need Sliding Glass & Patio Doors Right Now

• The door shudders or jumps when you slide it. A smooth-running slider should move with two fingers of pressure. If your door rattles in its track or hops over a flat spot, the rollers are chewed up and the track may be scored. Continuing to force the door will only deepen the damage to both.
• You see daylight or feel air moving around the closed door. Stand inside with the door shut and run your hand along the top, bottom, and latch jamb. Air movement means the weatherstripping is dead or the panel has dropped out of alignment. In July, that gap is paying your electric bill for air you are not cooling.
• The glass is fogged between the panes. A failed seal in an insulated glass unit cannot be repaired; the trapped moisture has already etched the interior glass surface. The sooner the lite is replaced, the less damage the frame absorbs from constant condensation working into the aluminum or wood.
• The door binds at the latch or will not lock without lifting. When a slider falls out of square, the latch hooks miss the strike plate and the door will not secure. This is not just inconvenient; an unlocked door on a ground-floor patio is an invitation. Realignment is a same-visit fix for our techs.
• The track is pitted or corroded from salt air. Boynton Beach sits in a corrosive coastal zone, and aluminum tracks left unpainted will pit and flake within a few years. A pitted track eats new rollers in a matter of months. We replace the track or install a vinyl cap so the repair lasts.

Our Sliding Glass & Patio Doors Process - Step by Step

1. 1
   Measure and inspect the opening. We measure the rough opening twice, check the floor for level, and note the existing frame material. In older Boynton Beach homes, floors have often settled, and we account for that before ordering or pulling a door. We also inspect the header and jambs for rot or termite damage that would compromise the install.
2. 2
   Quote the job on paper. You get a line-item quote showing the door, hardware, labor, and any trim or stucco work. We quote manufacturer lines side by side when you are choosing between PGT, CGI, or another brand, so you see the actual price difference, not a sales pitch. There are no surprise line items added after the fact.
3. 3
   Remove the old door and prep the opening. We pull the existing panel, track, and frame, then repair any water-damaged wood or corroded flashing. If the floor is out of level, we plane or shim the threshold area so the new door sits true. This is the most important step for a door that will glide for twenty years.
4. 4
   Set, square, and seal the new door. The new frame goes in plumb, square, and level, with flashing and sealant applied to Boynton Beach’s exposure standards. We set the rollers, adjust the latch strike, and run the panel back and forth until it moves with two fingers. Every adjustment is checked against a level, not a guess.
5. 5
   Register both warranty layers and walk the job with you. Before the truck leaves your driveway, both manufacturer warranty layers are registered in writing with their durations stated. We walk the door with you, show you the lock, the rollers, and the weep holes, and leave the job site swept. If anything is not done right, the Done Right Promise means we return and fix it, no arguing.

How Much Does Sliding Glass & Patio Doors Cost in Boynton Beach?

Sliding Glass & Patio Doors Near Boynton Beach - Our Service Area

TruePane installs and services sliding glass and patio doors throughout Boynton Beach and the surrounding coastal and inland communities. We routinely work in Sliding Glass & Patio Doors in South Palm Beach, Sliding Glass & Patio Doors in Golf, Lantana, Manalapan, Ocean Ridge, Gulf Stream, Atlantis, Delray Beach, Lake Worth Beach, Greenacres, and Palm Springs. For most sliding door repairs, we schedule within a day or two of your call. A live person answers the phone 24/7 at (561) 708-6771.

Frequently Asked Questions - Sliding Glass & Patio Doors in Boynton Beach

Schedule Your Sliding Glass & Patio Doors Service in Boynton Beach Today

Call TruePane at (561) 708-6771 for a free, no-obligation estimate on your sliding glass or patio door. We quote the job on paper, register both warranty layers in writing, and stand behind the work with the Done Right Promise. A live person answers the phone 24/7, and we will be there when we say.