Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Sliding glass doors
Impact garage doorsPGTCGI
Before
After
Before
After
Before
AfterFast, Reliable Door Installation Across Palm Springs
Door installation in Palm Springs, FL almost always starts the same way: with a corroded aluminum jalousie or sliding door that’s been leaking into an unflashed rough opening since the Eisenhower years. We replace it, rebuild the opening properly, and set a new impact-rated door that meets Palm Beach County wind-borne debris requirements. If you live off Greenbrier Drive, Congress Avenue, or anywhere else in the village, call (561) 708-6771 and we’ll schedule a free estimate. We know these CBS homes because we’ve worked on hundreds of them.
Key Takeaways:
- Most door replacements in Palm Springs require a permit and impact-rated glazing under Florida Building Code.
- Rough opening remediation (flashing, rot repair, stucco work) is standard on 1950s-1970s CBS homes here.
- TruePane registers both manufacturer warranty layers in writing before the truck leaves your driveway.
- Free estimates, fixed pricing in writing, and the Done Right Promise on every job.
Why TruePane Windows & Doors Is Palm Springs’s Preferred Door Installation Company
TruePane has been doing this work since 2008, founded by second-generation glazier Dale Kessler on a rule that still governs every install: if the pane is not true, the job is not done. Palm Springs homeowners call us because we understand what’s behind their door frames before we remove them. Our Door Installation team has replaced entry doors, French doors, and sliding glass doors in CBS homes throughout Palm Springs, and we know what to expect when we pull a jamb that was set directly into block with no flashing tape in 1962.
We carry background-checked, uniformed technicians on every job, and we measure every opening twice before a single order goes to the manufacturer. That matters in Palm Springs, where door rough openings are rarely square after sixty years of settling, salt air, and hurriçane cycles. We quote manufacturer lines side by side on paper so you see exactly what you’re buying, and both warranty layers are registered in writing before the truck leaves your driveway. That’s The Keystone Standard, and it’s how we’ve earned a strong local reputation in this village.
Our Door Installation Services in Palm Springs
Every Impact Windows & Doors in Palm Springs we install is specified for the wind-borne debris region and the salt-influenced air that drifts in from the Lake Worth Lagoon. Here’s what we handle most often in this village.
Entry & Swing Doors
Entry doors in Palm Springs’s older CBS homes are rarely a simple swap. The original frame was often bedded directly into the block with no flashing, which means water has been working its way behind the jamb for decades. We rebuild the rough opening first, then set a factory-finished fiberglass or steel door with new threshold pan flashing and sealant. It’s the difference between a door that looks fine for two years and one that stays dry for thirty.
Double & French Doors
Double and French doors are common on the 1960s ranches and 1970s villas throughout Palm Springs, especially where a dining room or living room opens to a screened patio. In this village, we spec impact-rated insulated glass units with reinforced mullions and multi-point locking hardware. The lead time on a custom-painted double door can run eight to twelve weeks, so we fix the price in writing before ordering and don’t change it after.
Bifold & Folding Doors
Bifold and folding door systems are heavier than they look, and in a Palm Springs CBS home the header above the opening often needs reinforcement before the hardware goes up. We handle the structural check, the flashing, and the weathersealing as part of the install. When a folding door is rated for Palm Beach County wind loads, it’s a different animal than what most online retailers ship, so we quote local-code-compliant systems from the start.
Pivot Doors
Pivot doors are a growing request from Palm Springs homeowners doing full facade updates. A pivot door changes the load path entirely; the hinge is in the floor and header, not the jamb, which means the framing tolerances are unforgiving. We coordinate with the door manufacturer, the structural scope, and the stucco contractor so the door motion is smooth on day one and stays that way. These are long-lead, custom jobs, and we price them with the lead time built in.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Palm Springs
We’re an authorized installer for more than a dozen manufacturer lines, and for Palm Springs we lean on brands that build specifically for South Florida’s wind and salt environment: PGT, and Ply Gem are the three we quote most often here. Each of those manufacturers builds impact-rated doors with coastal-corrosion-resistant hardware options, which matters in this village more than most people realize until their hinges start pitting. Because we’re local and cover Palm Springs regularly, we can also get replacement hardware and warranty parts faster than a contractor running up from Miami for a callback. We service what we install, and we stock common replacement weatherstripping and thresholds for these three lines.
Common Door Installation Problems We See in Palm Springs Homes
Palm Springs has a specific housing stock and a specific climate, and they combine into a predictable set of door failures. Here’s what we run into most often:
- Rotted rough openings behind old jambs. In 1950s-1970s CBS homes, original aluminum door frames were set directly into block with no flashing tape. By the time the door is replaced, the rough opening is often spalled, wet, and rotted at the bottom corners. We rebuild it before setting anything new.
- Corroded jalousie or sliding door hardware. Salt-influenced air from the Lake Worth Lagoon accelerates corrosion on aluminum hinges, sill tracks, and weatherstripping. Doors become impossible to operate smoothly, and the fix is full replacement, not lubrication.
- Non-impact doors ordered without a permit. Palm Springs sits inside Palm Beach County’s wind-borne debris region. If a door isn’t impact-rated or protected by an approved shutter, the permit gets rejected and the homeowner eats a reorder plus added lead time. We never let that happen.
- Undersized headers on wide openings. Older CBS homes in Palm Springs were built with minimal headers above door openings, especially on rear patio walls. Installing a heavier impact-rated French or bifold door without checking the header is how you get a sagging door and a cracked interior finish.
In a 1963 CBS home off Greenbrier Drive, we removed a badly oxidized sliding patio door in Palm Springs and found the original aluminum frame bedded directly into the block with no flashing tape anywhere. We cut back the spalled stucco, installed a new pressure-treated buck with full flashing tape, and set a Marvin impact-rated sliding door with low-E glass. The homeowners received their Palm Beach County opening protection credit and, after a summer of record heat, saw their cooling bills drop by over 15 percent. That job is the standard we hold every Palm Springs install to.
Pricing for Door Installation in Palm Springs, FL
A standard single entry door replacement in Palm Springs typically runs $1,800-$3,500 installed, depending on whether the rough opening needs remediation and which brand you choose. Double French door installations run $4,000-$8,500, and custom pivot doors with structural work start around $7,000 and climb with hardware and finish selections. If the existing opening is rotted, flashing and rough-opening rebuild work typically adds $600-$1,400 depending on how far the damage extends into the block and stucco. The biggest cost driver in this village is rarely labor; it’s whether you’re replacing a jalousie or sliding door with an impact-rated unit that requires a permit, opening protection credit documentation, and structural review. We quote fixed prices in writing before ordering, and we don’t add change orders after the fact. Call (561) 708-6771 for an exact figure; estimates are free.
We Also Serve Cities Near Palm Springs
If you’re outside the village, we also provide Door Installation in Palm Springs neighbors like Boynton Beach, South Palm Beach, Golf, and Lantana. The housing stock changes fast once you cross Lake Worth Road, so we always quote each home against its actual condition rather than a generic zip code price sheet.
Serving Palm Springs, FL - Our Local Coverage Area
We’re based in the Palm Springs area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Door Installation in Palm Springs
Because Palm Springs sits inside Palm Beach County’s wind-borne debris region under the Florida Building Code, which requires every exterior door opening to be protected to current FBC standards, either with impact-rated glazing or an approved shutter system. This means a permit is required for almost any exterior door replacement, and the door you order must be rated for the wind zone. We pull the permit, schedule the inspection, and provide the documentation your insurance company needs for an opening protection credit. Call (561) 708-6771 and we’ll walk you through exactly what your project needs.
Original aluminum door frames set directly into concrete block with no flashing tape are the biggest cause of rot in Palm Springs CBS homes. Water seeps in between the frame and the block, sits against the rough buck and the bottom corners of the opening, and rots everything from the inside out over decades. By the time the door is pulled, the damage is almost always worse than it looked from outside. We rebuild the opening, flash it properly, and set the new door on a pressure-treated buck so it stays dry. Call (561) 708-6771 for an inspection if your jamb feels soft or you see stucco cracking at the corners.
Yes, if the replacement is a properly documented impact-rated door. Florida insurers apply opening protection credits when you upgrade from unprotected openings like jalousie doors to impact-rated systems or documented shutter protection. The discount is tied to the permit record and the product approval documents, so it’s important that the installer registers the warranty and provides the paperwork. We provide that documentation as part of every Door Installation job in Palm Springs, and our customers routinely see meaningful premium reductions. Call (561) 708-6771 for a free estimate and we’ll explain exactly how the credit works for your home.
Yes, but almost always with opening modification. Many 1960s CBS homes in Palm Springs were built with 30-inch or 32-inch rough openings, which are narrower than most modern energy-efficient door units. In most cases we can widen the opening by cutting back the block and installing a new header and king studs. The work adds cost and time, but it’s documented, permitted, and structural. We’ll tell you honestly whether your opening can carry a wider door and what the structural scope looks like before you order anything. Call (561) 708-6771 to have us measure your opening.
Salt air from the Lake Worth Lagoon and year-round humidity accelerate corrosion on bare aluminum hardware, pitting hinges and seizing sill tracks within a few years, and they degrade weatherstripping faster than manufacturers’ average lifespans predict. That’s why we specify coastal-rated hardware and stainless-steel fasteners on every exterior door in Palm Springs, not just the ones on the water. It’s also why we register both warranty layers in writing before the truck leaves your driveway, so a corrosion-related failure is covered, not argued over. Call (561) 708-6771 for a free estimate.
Get Your Door Installation Quote in Palm Springs
If you live in Palm Springs and you’re tired of a door that binds in the humidity, leaks at the sill, or simply won’t close square anymore, call TruePane Windows & Doors at (561) 708-6771. We’ll measure, quote, and schedule. The estimate is free, the price is fixed in writing before ordering, and the work is guaranteed by the Done Right Promise. A live person answers the phone 24 hours a day, 7 days a week. We’ll be there when we say.
Written by Dale Kessler, Owner at TruePane Windows & Doors, serving Palm Springs and Palm Beach County.
Six Reasons Homeowners Choose TruePane Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.