Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Sliding glass doors
Impact garage doorsPGTCGI
Before
After
Before
After
Before
AfterMr-Glass Roof Repair in Boynton Beach: What to Know First
Mr-Glass roof repair in Boynton Beach is work we take on as an independent service provider, and most jobs are completed same-day or next-day once we’ve seen the opening. You’ll get an upfront line-item price before any work starts, not a vague estimate that shifts once the old unit comes out. If you’re a Mr-Glass owner in Boynton Beach with a leak, a cracked panel, or a frame that’s pulling away from the roofline, call (561) 708-6771 and we’ll schedule a look.
This page is written for homeowners in Boynton Beach who already own a Mr-Glass roof product, whether that’s a skylight, a sloped glazing system, or a glass roof section over a patio or sunroom. We’re not affiliated with Mr-Glass and we don’t claim to be. What we are is a local company that’s repaired enough of their units in Palm Beach County to know where they fail and what it takes to fix them right.
How Mr-Glass Products Fail, and How We Fix Them
- Seal failure at the aluminum profile joints on Mr-Glass’s Structural Glazing Line. The silicone wet seals between glass lites and aluminum mullions break down after years of sun and salt air, and we see it first at the low corners where water pools. The symptom is condensation between the lites or a slow drip that only shows up in a hard east wind. Our fix is a full debridement of the old sealant, a marine-grade primer pass, and a two-bead structural silicone reseal; we never smear a cosmetic bead over rotted sealant.
- Gasket compression set on the Mr-Glass Series 4500 skylight curbs. The EPDM gaskets between the glass and the curb dry out and lose their rebound, leaving a gap that leaks when a Boynton Beach afternoon storm drives rain sideways. Owners often mistake this for a flashing problem, but the flashing is usually fine. We replace the gasket with an equivalent durometer EPDM and re-torque the retaining clips to the manufacturer’s original spec; if the curb itself shows hairline cracking at the weld tabs, we address that before the new gasket goes in.
- Fractured tempered glass panels on Mr-Glass pool-enclosure roof sections. Tempered glass fails as a full shatter, not a crack, and the cause here is usually a nickel sulfide inclusion on older Mr-Glass panels or thermal stress from a shadow line that hits the panel at a sharp angle every afternoon. Either way, the replacement panel has to match the original thickness and tint or the roof will look patchy in full sun. We source OEM Mr-Glass glass through our distributor network and verify edge finish and heat-soak history before the panel is ordered.
- Weep-hole blockage and internal drainage failure in Mr-Glass rafter glazing. Mr-Glass rafter systems channel water through an internal gutter. When the weep holes at the rafter ends clog with wind-blown sand and leaf debris, water backs up and overflows onto the interior side of the frame. It looks like a roof leak but it’s actually a drainage failure. We flush the internal channels, clear the weeps, and replace the debris screens with a finer mesh when the home sits under heavy tree cover.
- Condensation-fogged insulating glass units in Mr-Glass conservatory roofs. Double-pane Mr-Glass units lose their desiccant over time, and once the argon or krypton fill leaks out, the unit fogs permanently. No amount of wiping fixes it; the IGU has to be replaced. We measure the exact glass size on-site, order a matched IGU, and set the new unit into the existing Mr-Glass frame without disturbing the surrounding glazing stops.
Our Mr-Glass Roof Repair Process
- 1
The call. You reach a live person at (561) 708-6771, day or night. We ask a few questions about the symptom, get your address in Boynton Beach or nearby, and schedule a time that works.
- 2
The inspection. A uniformed, background-checked technician shows up on time and works through the system: glass condition, sealant integrity, gasket compression, drainage paths, and the curb or frame-to-roof connection.
- 3
The quote. You get a written line-item price before any work begins. If we can repair rather than replace, we say so. If replacement is the honest call, you’ll see exactly what a new panel, IGU, or gasket set costs, and we’ll quote OEM and quality aftermarket side by side when both are viable.
- 4
The repair. We do the work the same visit in most cases, and we respect the house: drop cloths under the work area, shoes off the furniture, and no debris left in the pool or on the patio.
- 5
The test. After the repair, we water-test the area with a controlled hose run along the roofline and check the interior for any moisture transfer. If the pane is not true, the job is not done.
- 6
The paperwork. You get a written summary of the work, the parts used, and the Done Right Promise covering our labor. If a manufacturer warranty is in play on the new part, we register it in writing before we leave.
What Mr-Glass Roof Repair Costs in Boynton Beach
Mr-Glass roof repair in Boynton Beach typically falls in the $250 to $1,800 range depending on what failed. Here are the common scenarios we quote:
| Repair Type | Typical Cost Range |
|---|---|
| Reseal aluminum profile joints (per seam) | $180 to $320 |
| Replace EPDM gasket on skylight curb | $250 to $450 |
| Clear weep holes and internal drainage channels | $150 to $300 |
| Replace single tempered glass panel | $500 to $950 |
| Replace fogged insulating glass unit | $650 to $1,200 |
| Full roof section overhaul (reseal, new gaskets, hardware) | $1,200 to $1,800 |
What moves the price is access: a one-story pool enclosure over concrete is faster than a second-story conservatory roof over a garden. OEM glass costs more than a quality aftermarket match, and we’ll show you both numbers honestly. Call (561) 708-6771 and we’ll come out and give you a written quote, free.
Why Boynton Beach Homeowners Call TruePane Windows & Doors for Mr-Glass Work
Dale Kessler grew up off Lawrence Road in the Meadows section of Boynton Beach, and he’s been setting glass and frames across Palm Beach County for the better part of two decades. He knows this climate: the salt air, the afternoon storm pattern, the way a June sun hits a western-facing run of glazing. That’s why our techs inspect the whole opening, not just the visible damage.
Every Mr-Glass repair we do is covered by the Done Right Promise. If it’s not done right, we make it right, no paperwork and no arguing. And because we’re an authorized installer for more than a dozen lines including PGT, CGI, CWS, and ES Windows, we’re not cornered into pushing a replacement you don’t need just because we only carry one brand. We quote what’s best for the house and we stand behind it in writing. That’s a square deal, and that’s how we’ve operated in Boynton Beach since day one.
FAQs
No, we’re an independent Mr-Glass service provider. We’re not authorized by Mr-Glass and we don’t represent ourselves that way. We’re authorized installers for more than a dozen other manufacturers including PGT, CGI, CWS, and ES Windows, and we repair Mr-Glass products because they’re common in Boynton Beach homes and the work is well within our trade.
For most Mr-Glass products older than five years, the original warranty has either expired or covers only the glass, not the seals, gaskets, or frame. If your unit is still under warranty, call Mr-Glass first and see what they’ll cover. If the warranty path is a dead end, call us at (561) 708-6771 and we’ll give you an honest quote for the repair.
Yes, in almost every case. We match the original thickness, tint, and edge finish, and for tempered panels we verify heat-soak history before ordering. OEM Mr-Glass glass is available through our distributor network for most lines, and when it’s not, we source a quality aftermarket match and show you both options on paper.
Most Mr-Glass roof repairs in Boynton Beach are completed the same or next day once we’ve seen the opening and confirmed the parts needed. Specialty glass or a custom IGU may add a few days for fabrication and delivery. Call (561) 708-6771 and we’ll give you a straight answer on timing for your specific job.
If the frame and curb are structurally sound, repair is almost always the cheaper and faster call. If the aluminum is corroded through, the curb is cracked, or multiple panels have failed, replacement starts to make more financial sense, and we’ll walk you through both numbers honestly. Call (561) 708-6771 for a free inspection and a written estimate.
Written by Dale Kessler, Owner, TruePane Windows & Doors at TruePane Windows & Doors, serving Boynton Beach and nearby areas.
Six Reasons Homeowners Choose TruePane Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.